Chrysler 26 - Hull work advice
Posted: Wed Jun 02, 2021 11:57 am
Hi,
There are a few things I would like to do to complete my 1978 Chrysler 26 restoration. Here is a video I made of the work thus far.
https://www.youtube.com/watch?v=EshWSrVCJe0
The work I would like to do at the end of the season if to do the following:
1. Take off the old ablative paint and repaint the bottom
2. Replace the swing keel cable.
3. Replace the swing keel pivot point hinge.
Are these things I should get done at a shipyard? Anyone have recommendations for one in the Erie PA area? I have the boat on a trailer and cannot get to the swing keel cable very easily.
Thanks!
There are a few things I would like to do to complete my 1978 Chrysler 26 restoration. Here is a video I made of the work thus far.
https://www.youtube.com/watch?v=EshWSrVCJe0
The work I would like to do at the end of the season if to do the following:
1. Take off the old ablative paint and repaint the bottom
2. Replace the swing keel cable.
3. Replace the swing keel pivot point hinge.
Are these things I should get done at a shipyard? Anyone have recommendations for one in the Erie PA area? I have the boat on a trailer and cannot get to the swing keel cable very easily.
Thanks!