Rebuilding my 1979 Chrysler

Any ideas, suggestions, concerns about this board? Here's the place to discuss them.

Moderator: CaptainScott

michigansailor
Posts: 4
Joined: Sun Apr 26, 2015 6:22 pm

Rebuilding my 1979 Chrysler

Postby michigansailor » Sat May 09, 2015 4:21 pm

Hey Guys, I am rebuilding my 26' Chrysler and need a new rudder shaft bearing for my boat. I took my rudder apart and found that mine is broken and has been repaired once already. I am not sure if anyone knows where I could get one or how to make something that will fit.

Thanks I would love to get it fixed so I could put it in the water this summer.

Thanks Michigan Sailor

User avatar
CaptainScott
Site Admin
Site Admin
Posts: 3068
Joined: Wed Sep 24, 2008 10:46 am
Location: Washington State
Contact:

Postby CaptainScott » Sat May 09, 2015 6:21 pm

Welcome to the forum Michigan sailor!
You might want to post this in the general discussion as most folks do not visit this discussion area much!

Again,
WELCOME!

Scott

Skipper Dan
Posts: 18
Joined: Sat Dec 09, 2017 11:33 am

Re: Rebuilding my 1979 Chrysler

Postby Skipper Dan » Fri May 04, 2018 1:20 pm

I think you can get them at rudder craft very well made I did mine

B&G Clinger
Posts: 9
Joined: Sun Jul 15, 2018 2:39 pm

Re: Rebuilding my 1979 Chrysler

Postby B&G Clinger » Sat Sep 29, 2018 4:20 pm

Another Michigander!! Where to you sail out of?


Return to “Board Discussion”

Who is online

Users browsing this forum: No registered users and 1 guest