New to me C22 Concern with Rudder Assembly

Here you can discuss Chrysler Sailing across all makes of Chrysler sailboats.
Post Reply
azbrad
Posts: 2
Joined: Tue May 28, 2019 8:19 pm

New to me C22 Concern with Rudder Assembly

Post by azbrad »

Greetings everyone, thank you for taking the time to read! I am contemplating the purchase of a Chrysler 22 for a weekend cruising lake boat. The owner is stating rudder was bent when last taken out of water. Picture shows what looks to be a through hull bushing broken, is this a difficult fix? Boat shows pride of ownership and well taken care of but a 6 hour drive away. Should this issue prevent me from purchasing the boat?
Attachments
C22 Rudder 2.jpg
C22 Rudder 1.jpg
User avatar
C22Bob
Site Admin
Site Admin
Posts: 143
Joined: Mon Sep 24, 2012 12:03 pm
Location: Knoxville TN

Re: New to me C22 Concern with Rudder Assembly

Post by C22Bob »

All depends on whether the hull was damaged in the process. That SS shaft is very sturdy and the amount of force needed to bend it could have damaged the fiberglass. I would ask for some closeup pix of the hull from both sides.

Here's some of my rudder work
Rudder Upgrade
User avatar
CaptainScott
Site Admin
Site Admin
Posts: 3111
Joined: Wed Sep 24, 2008 10:46 am
Location: Washington State
Contact:

Re: New to me C22 Concern with Rudder Assembly

Post by CaptainScott »

Welcome to the forum.

For what it is worth,
I had a C22 with bent/damaged rudder plates similar to the pictures shown.
Found a local welder that could build a new rudder shaft and plates for me very reasonably priced.

I also replaced the bushing and do not recall it being a problem finding one. It has been quite a while though since I did any of that work.

Scott
Skipper Dan
Posts: 106
Joined: Sat Dec 09, 2017 11:33 am

Re: New to me C22 Concern with Rudder Assembly

Post by Skipper Dan »

New bushings are available and not that expensive, plus they are better than original. I believe you get them from a rudder manufacturer. The two white mushroom shaped thingies.
Attachments
new parts.jpg
User avatar
C22Bob
Site Admin
Site Admin
Posts: 143
Joined: Mon Sep 24, 2012 12:03 pm
Location: Knoxville TN

Re: New to me C22 Concern with Rudder Assembly

Post by C22Bob »

Post Reply