Only had one Jam cleat on the tiller. Made it with 3/8 rope but I cut it to 5 feet. it worked out perfect.Reality wrote:there are (should be) two jam cleats on the tiller. Diameter would be based on what works with these cleats. 3/8 sounds about right. I'd start with 4' lengths and trim if needed.
Search found 4 matches
- Mon Jul 09, 2018 12:53 pm
- Forum: General Chrysler Sailing Discussion
- Topic: Size of Rope on tiller
- Replies: 2
- Views: 11653
Re: Size of Rope on tiller
- Mon Jul 09, 2018 12:52 pm
- Forum: General Chrysler Sailing Discussion
- Topic: Mast Crutch instalation
- Replies: 2
- Views: 9620
Re: Mast Crutch instalation
I did something similar with mine. Used a 1 1/4" x 4' square tubbing with a 1" x 4' square tubing inside it. Was able to weld a roller on top. that way I can use it to transport the mast then extend it up for mounting. Attached to the transom motor mount but with the engine on its going to...
- Thu Jul 05, 2018 8:34 am
- Forum: General Chrysler Sailing Discussion
- Topic: Size of Rope on tiller
- Replies: 2
- Views: 11653
Size of Rope on tiller
Have noticed a lot of web discussion on rigging and size of running rigging on a Chrysler 22. I have not found out what diameter rope is used on a swing tiller or the length. Need to be replaced and not much to go on. Notice one discussion that a person had used a Green rope for the down position an...
- Thu Jul 05, 2018 8:29 am
- Forum: General Chrysler Sailing Discussion
- Topic: Mast Crutch instalation
- Replies: 2
- Views: 9620
Mast Crutch instalation
Just recently bought a 1976 Chrysler 22. It has been sitting for30 years without being used. Been reading a lot from the forum and the website to get the boat back to pristine shape. Question is how would you attach a Mast Crutch to the back of the C-22? I have seen a lot of them used on Catalina 22...