Search found 12 matches
- Sun Oct 30, 2011 1:46 pm
- Forum: Sails
- Topic: MAIN SAIL TO LARGE?
- Replies: 7
- Views: 27279
- Thu Sep 15, 2011 2:50 am
- Forum: General Chrysler Sailing Discussion
- Topic: T_ SHIRTS! finally!!!!! CHECK IT OUT!
- Replies: 81
- Views: 396354
- Fri Sep 02, 2011 2:00 pm
- Forum: DaySailors
- Topic: New C-15 Man O War owner questions re: flotation, etc.
- Replies: 7
- Views: 18322
Re: New C-15 Man O War owner questions re: flotation, etc.
Welcome! I'm fixing a 13' Barracuda, so we're pretty much in the same boat (pun intended). That being said: I got bitten by the sailing bug in July 2011. d) What is the ideal size rope to use for the sheet (length and diameter). The only sizes specified in the manual are: 48-inch piece of 3/16-inch ...
- Fri Sep 02, 2011 1:48 pm
- Forum: General Chrysler Sailing Discussion
- Topic: I gotta get one of these...
- Replies: 6
- Views: 8638
- Tue Jul 26, 2011 4:44 am
- Forum: General Chrysler Sailing Discussion
- Topic: C-13 Barracuda "restoration" discussion
- Replies: 15
- Views: 14751
- Mon Jul 25, 2011 9:48 pm
- Forum: General Chrysler Sailing Discussion
- Topic: C-13 Barracuda "restoration" discussion
- Replies: 15
- Views: 14751
Another question here, the hull was all dirty and the paint corroded as in picture 1, and after sanding it down to picture 2, noticed that it was still uneven and very scratched up and rough. After taking it down further, I noticed that in some parts, there was wood beginning to peek through (pictur...
- Mon Jul 25, 2011 1:20 pm
- Forum: General Chrysler Sailing Discussion
- Topic: You need this !
- Replies: 4
- Views: 5341
- Sun Jul 24, 2011 3:55 pm
- Forum: General Chrysler Sailing Discussion
- Topic: C-13 Barracuda "restoration" discussion
- Replies: 15
- Views: 14751
- Sun Jul 24, 2011 3:10 pm
- Forum: General Chrysler Sailing Discussion
- Topic: C-13 Barracuda "restoration" discussion
- Replies: 15
- Views: 14751
- Sun Jul 24, 2011 2:45 pm
- Forum: General Chrysler Sailing Discussion
- Topic: C-13 Barracuda "restoration" discussion
- Replies: 15
- Views: 14751
- Sun Jul 24, 2011 2:16 pm
- Forum: General Chrysler Sailing Discussion
- Topic: C-13 Barracuda "restoration" discussion
- Replies: 15
- Views: 14751
So, an hour later and I got them off, but it seems that it's been one step forward and two steps back. The port side plate I could remove one screw, bend the metal around the other, and lift up, but it was still held in by the rivets that hold in the rub rail. On the starboard side, the screws are t...
- Sun Jul 24, 2011 12:48 pm
- Forum: General Chrysler Sailing Discussion
- Topic: C-13 Barracuda "restoration" discussion
- Replies: 15
- Views: 14751
C-13 Barracuda "restoration" discussion
Hello all, I recently bought a 13 foot Barracuda in less than optimal condition hoping to restore it to it's full potential. However, the plates that hold down the mast cables are in poor condition, and was going to replace them. After searching high and low and not finding anywhere to replace them,...